Please verify that the installation of the Skywire is correct. If it is installed 180
degrees from the proper orientation, or if the Skywire is installed one pin off, it
will damage the Skywire modem when power is applied. This voids the warranty
of the Skywire and the NL-M1DK.
Attach the antenna cables to the Skywire.
Note: when removing antenna cables from the Skywire, use a U.FL removal tool.
Here is a picture of the fully-installed Skywire:
2.2.3 Jumper Installation
The NL-M1DK has the capability to connect to your workstation via a USB-Serial
connection, or to different microcontroller platforms. Your NL-M1DK is setup from the
factory for the USB-Serial connection. However, if a jumper was knocked off during
shipment, here is a diagram for the proper jumper settings:
PN 30192 rev 10
© NimbeLink Corp. 2018. All rights reserved.
10
