![Nilfisk-ALTO SCRUBTEC 545B User Manual Download Page 78](http://html1.mh-extra.com/html/nilfisk-alto/scrubtec-545b/scrubtec-545b_user-manual_1693924078.webp)
ENGLISH
USER MANUAL
20
SCRUBTEC 545B – 545BL – 553B – 553BL – BOOST 5
9097054000(2)2009-06 A
TANK EMPTYING
An automatic
fl
oat shut-off system (36) turns off the vacuum system when the recovery tank (21) is full.
The vacuum system deactivation is signalled by a sudden increase in the vacuum system motor noise frequency, and the
fl
oor is
not dried.
CAUTION!
If the vacuum system turns off accidentally (for example, when the fl oat is activated because of a sudden
machine movement), to resume the operation: turn off the vacuum system by pressing the switch (73), then
open the cover (22) and check that the fl oat inside the grid (36) has gone down to the water level. Then close the
cover (22) and turn on the vacuum system by pressing the switch (73).
When the recovery tank (21) is full, empty it according to the following procedure.
Recovery tank emptying
Stop the machine.
1.
Lift the brush/pad-holder deck by pressing the pedal (11).
2.
Lift the squeegee (25) with the lever (10).
3.
Drive the machine to the appointed disposal area.
4.
Empty the recovery tank with the hose (16). Then, rinse the tank with clean water.
5.
Solution/clean water tank emptying
Perform steps 1 to 4.
1.
Empty the solution tank with the hose (17). Then, rinse the tank with clean water.
2.
AFTER USING THE MACHINE
After working, before leaving the machine:
Remove the brush/pad-holder as shown in the relevant paragraph.
1.
Empty the tanks (20 and 21) as shown in the relevant paragraphs.
2.
Perform the daily maintenance procedures (see the Maintenance chapter).
3.
Store the machine in a clean and dry place, with the brush/pad-holder and the squeegee lifted or removed.
4.
MACHINE LONG INACTIVITY
If the machine is not going to be used for more than 30 days, proceed as follows:
Perform the procedures shown in After Using the Machine paragraph.
1.
Disconnect the battery connector (12).
2.
FIRST PERIOD OF USE
After the
fi
rst 8 hours, check the machine fastening and connecting parts for proper tightening and check the visible parts for
integrity and leakage.
Summary of Contents for SCRUBTEC 545B
Page 115: ......