Nilfisk-Advance SH SOLAR G, Instructions For Use Manual, Page: 28 / 34

28 Original Instructions
SH SOLAR G, GH, GW
"Air Control Failure" > The air pressure gauge on the • Adjust the air pressure gauge
booster blower is not activated
properly.
> The booster blower is not • Make sure that the booster
generating su ffi cient pressure blower is functioning, and
that inlet is not blocked.
7.3 Error messages, GH models (gas heated)
If heating cannot be switched on or is switched o ff without any error messages, it is likely that the over-
heat protection (pos. 14 on illustration at the end of the manual) has tripped. Unscrew the dust cap,
and push the rod to reset the overheat protection switch. If this error re-occurs call Nil
fi sk service.
Error Message
(red STOP light fl ashing) Reason Action
Pump oil level low > Level of lubricant oil of HP • Remove cabinet and top up
pump is at a low level oil if no leakage is present.
• Call Nil fi sk service if
oil is leaking or if water is
mixed in the oil (creamy
white or transparent)
Overload cut out > Overload or short circuit of • Call Nil fi sk service.
the machine.
Water shortage > Lack of water in heating tank • See section “ 3.10 Venting ”
• Check your water supply
– open?, su ffi cient pressure?
• Check and clean inlet fi lter,
section 6.2.
Risk of leakage > Water inlet magnet valve has • Check the fl ow rate from
been open more than 10 your water supply.
minutes • Inlet magnet valve defective
– call Nil fi sk service.
• Leakage in tank or internal
feed system – call Nil fi sk-
service.
Motor cut out > Motor is not running • Motor overheated – let the
machine cool down and retry.
Check pressure and clean
nozzle if too high.
• Cooling of motor damaged
– call Nil fi sk service.
• Other motor problems – call
Nil fi sk service.
Burner failure – press heat > The gas burner has detected • Call Nil fi sk service.
ON/OFF button and hold an error in the burner system:
for 2 sec . • Lack of gas.
• No ignition.
• Other errors.
E3
E2
E1
E10
E8
E9
E11