12
Original Instructions
EN
DA
NO
SV
FI
DE
FR
NL
IT
ES
PT
EL
TR
CS
HU
PL
HR
SL
SK
LV
LT
ET
RU
ZH
4.3 Water Connection
IMPORTANT!
Connecting to pressurized water supply
The inlet water max. pressure is 1 MPa/10 bar and the max. temperature is 60°C – see rating
plate. An ordinary ½" garden hose of min. 10 m and max. 25 m will be suitable.
B6
Check that the fi lter is fi tted in the water inlet pipe and that it is not clogged up.
B7
Connect the water hose to the water supply by means of the quick connector. Turn on the
water.
Connection to the drinking water mains according to national and local regulations.
Let the water run through the water hose before connecting it to the machine to prevent sand
and dirt from penetrating the machine.
B8
Turn off the water and connect the water hose by means of the quick coupling to the wa-
ter inlet.
Connecting to pressure less water supply
The machine can also operate in suction mode, meaning that you can connect the machine to
e.g. rainwater vessels, rivers, lakes and cisterns etc. When taking in water from non drinking
water mains the backfl ow preventer is not needed.
When connecting the machine to operate from pressure less water supplies – always use ad-
ditional fi ltering to secure that impurities are not sucked in. Hose length should be max. 3 meter
and of minimum ½".
To meet these requirements, Nilfi sk recommends that you use the original Nilfi sk suction hose
kit.
The Machine is designed for suction up to 100 cm above water surface.
• Position the machine at max. 1.0 meter above the water surface. Detach the high pressure
hose from the outlet.
• Ensure that the inlet fi lter is in position and attach the suction hose kit, secure tight connec-
tion to the inlet.
• Turn on the machine, turning the start/stop switch (1) to position "
I
".
• Wait until a steady jet exits the outlet.
• Switch off the machine and attach high pressure hose (4), spray handle, lance and nozzle.
• Start the machine again and activate the spray handle.
4.4 Starting the high pressure washer
IMPORTANT!
Connecting to mains power supply
The voltage and frequency of the machine (see model tag (14)) must match the voltage and
frequency of the power supply.
Connecting the high pressure washer to a supply system, the max allowed impedance is =
0,29+j0,18
(Zmax). Consult with the supply authority that the equipment is connected only to
a supply of that impedance or less.
B9
Insert the power plug into power supply socket.
B10
Turn on the water.
B11
Release the trigger lock (7a). Remember to unplug, turn off the high pressure washer and
lock the trigger, when leaving the high pressure washer unattended
B12
Activate the trigger of the spray handle and let the water run until all air has escaped from
the water hose.
B13
Turn on the machine, turning the start/stop switch to position "
I
".
B14
Activate the trigger of the spray handle. When releasing the trigger of the spray handle,
the machine automatically stops. The machine will start again when you reactivate the
trigger of the spray handle.
