Operation of High Speed Floor Machine
*Read operators manual thoroughly prior
to operating or servicing this machine.
GENERAL USE
1] Remove any obstructions or other
obstacles in the area which is to be
cleaned.
2] Remove dust recovery bag and empty it
out in a trash receptacle. Replace
dust recovery bag on machine, ensuring
it is sealed tightly to the machine.
3] Place handle in upright position and tilt
machine back until handle rests on the
floor.
*Be sure the machine is not plugged into
an outlet.
4] Remove the pad center gripping device
by unscrewing the thumbscrews.
5) Place a burnishing pad on the pad driver
and re-attach the center gripping
device.
6] Place machine back into its upright
position.
7] Plug power cord into grounded outlet.
*Do not use an extension cord in
conjunction with the standard power
cord.
8] The handle height may be adjusted by
lifting up on the handle release lever,
located on the right side of the
switch housing. Pull trigger and
lower handle to desired operating
position. Release trigger to lock
handle into place.
9] To start the machine, push on the red
safety release button located on the
top of the switch housing and
squeeze either switch lever.
10] When the machine is in operation,
both hands should be gripping on the
handle.
11] To stop the machine at any time,
simply release the switch lever, and the
machine will stop automatically.
4
