FORM NO. 56041590 / AX 300 / AX 400 - 13
LUBRICATION
Once a month, wipe the solution valve with a clean cloth. Then use a spray silicone lubricant on all pivot points associated with the valve
assembly, especially the valve plunger.
Once a month, lubricate the pivot points of the handle and the wheel axles. Wipe off any excess to avoid staining floor surfaces.
The Solution Valve Assembly is located on the bottom of the machine.
Valve Plunger
VACUUM MOTOR MAINTENANCE
Once a month, check the vacuum motor to make sure the airways are not blocked. Clean the dome lid on the recovery tank thoroughly.
Clear hoses of debris and keep the vacuum motor exhaust area clean.
Vacuum Exhaust
Float Ball and Cage
Vacuum Hose
VACUUM MOTOR AIRWAYS
Dome Lid
Recovery Hose
Recovery Hose
Vacuum Exhaust
Pick Up Tool
Have Nilfisk check the carbon motor brushes once a year or after 500 operating hours. Replace the carbon brushes if they are worn to 9.5
mm or less.
IMPORTANT!
Motor damage from failure to service the carbon brushes is not covered under warranty.
Summary of Contents for 56262054
