Installing the Security Bracket and Cable
1. With the loudspeaker in the proper location, turn the loudspeaker over so the
bottom of the loudspeaker is facing you, as shown in Figure 7.
2. Take the nylon security cable, supplied with the loudspeaker and fold it in half.
Using the middle of the cable, feed it through the Security Attachment Eyelet as
shown in Figure 8.
3. Feed the opposite end of the nylon security cable through the exposed portion
of the cable that was just fed through the security eyelet, as shown in
Figures 9 and 10.
4. Pull the ends of the security cable with
the loops as tight as you can until the
knot around the security eyelet is
tightened as shown in Figure 11.
5. Feed the Security Stake through the
loops at the end of the security cable
and insure that they are inserted into the
cable holder provided at the top of the
stake, as shown in Figure 12.
6. Pick a spot in the ground which the loudspeaker will cover and drive the security
stake all the way into the ground until the cable holder is completely under the
surface of the ground, as shown in Figure 13.
7. Pull on the security cable and verify that the stake is securely held in the ground.
Upgraded Security Attachment Method (Optional)
To perform this attachment method you will need the following items:
1. (1) Stainless Steel Eyebolt
2. (1) Concrete Anchor sized to the Stainless Steel Eyebolt
3. (1) Bag of Quikcrete – fast drying cement mix or equivalent
4. A post hole digger or shovel
5. (1) Stainless Steel Aircraft Cable 1/8" diameter or larger
6. (2) Stainless steel wire rope clamps sized to the aircraft cable chosen
To install an upgraded security system:
1. Prepare a hole that is at least one-foot deep, at a minimum (three-feet if
the speaker is being installed in an area that has a frost line). The hole should be
at least six inches in diameter. This hole should be under the desired location of
the loudspeaker.
2. Once the hole is prepared, mix the concrete per its’ instructions. Fill the hole
with concrete. Place the concrete anchor in the center of the concrete so the top
of the anchor is flush with the top of the concrete and the anchor is not filled
with concrete.
3. Wait until the concrete is dried per the instructions on the concrete
mix used.
4. Screw the stainless steel eyebolt into the concrete anchor
5. Feed one end of the stainless steel aircraft cable through the eyebolt in
the concrete
INST
ALLA
TION
INST
ALLA
TION
16
15
Figure 7 Bottom of Loudspeaker
Figure 8 Security Cable in Eyelet
Figure 9 Security Cable
Looping Through
Figure 10 Security Cable after Looping
Figure 12 Security Stake
Attachment to Cable
Figure 13 Security Stake
Driven into Ground
Figure 11 Security Cable
Connected and Tightened
