NIlEs AUDIO CORPORATION – 1-800-bUY-hIFI – 305-238-4373
13
3)
connect poweR supply peR RFG set-up
Based on the mode of the RFG, a niles
Power Supply may be needed (see
System
Considerations
section to see if optional power
supply is needed).
4)
Mount the RFG
(see
Figure 10
).
5)
AttAch the AntennA
the external antenna screws to the RFG
chassis as shown in
(
Figure 11
).
6)
oRient the AntennA
Adjust the flexible joint antenna so it is
vertical for maximum reception.
7)
set RF coMMunicAtion chAnnel
After the RFG is installed the RF channel must
be set. the default setting is RF channel 5, RF
network 1. the RF communication channel is
changed using configuration software. If the RFG is used as an end-Point with a
niles keypad, the communication channel is set in the keypad’s installer menu
(
see the keypad’s installation guide for installer menu information
). there are no RF
communication channel controls on the RFG itself.
Figure 10.
Wall mount placement.
use Sheetrock Screws
Figure 11.
Antenna connection