5
When the screen shown on the right is displayed, tap the camera name.
Connect to Camera
Camera name
KeyMission 360_xxxxxxxx
• If pairing is successful, the screen shown on the right is displayed. Follow the on-screen
instructions.
Connect to Camera
Connected to KeyMission 360_xxxxxxxx
Pairing Procedure (with NFC)
1
Make sure that the camera is off (the power-on lamp is off).
2
Enable Bluetooth, Wi-Fi, and NFC on the smart device.
• Do not pair from the Bluetooth setting screen of the smart device.
3
Install the SnapBridge 360/170 app.
4
Close all apps that use NFC, including the SnapBridge 360/170 app.
• Pairing may fail if apps that use NFC are running.
5
Press the movie button or photo button on the camera to put it into pairing standby mode.
• When the status lamps flash green at the same time for a while and then alternately flash green, the camera
enters pairing standby mode.
• If the camera remains in pairing standby mode for about 4 minutes, it turns off (the power-on lamp turns off )
automatically. If the camera turns off during the pairing procedure, press the movie button or photo button
on the camera to put it into pairing standby mode.
* If the camera does not enter pairing standby mode even after pressing the movie button or photo button,
press and hold the movie button for about 7 seconds while the camera is off.
6
Tap the NFC antenna of the smart device to the
Y
(N-Mark) on the camera.
• The SnapBridge 360/170 app starts. When
Camera name acquired. Connect?
is displayed,
select
OK
. If pairing is successful, the screen shown on the right is displayed.
Connect
When You Cannot Pair
Perform the following and then pair again by proceeding to “Pairing Procedure (without NFC)” or “Pairing
Procedure (with NFC)”.
• Press and hold the movie button on the camera for about 3 seconds to turn it off (when the camera turns off,
the power-on lamp turns off ).
• Close the SnapBridge 360/170 app.
Auto Off
By default, if the camera is not operated for about 30 seconds, the camera turns off automatically. We recommend
that
Auto off
is set to
5 min
until you are comfortable with operating the camera and app (set in
Camera
M
Camera settings
M
Auto off
in the app).
To Learn More About Using the SnapBridge 360/170 App
See the online help (tap
Other
M
Info/settings
M
Instructions
in the app).
