* Refer also to the Custom Setting Menu table at the end of this instruction manual.
1. Automatic film rewind at the end of film roll (page 29)
Options: 0: Activated (initial setting)
1: Disabled
At initial setting, film rewind is automatically started when the end of the film
roll is reached. However, the camera can be set not to rewind film at the end
of the film roll but instead film rewind is started by pressing the two film
rewind buttons for more than 1 sec.
2. Reset to DX film speed setting for new film (page 36)
Options: 0: Activated (initial setting)
1: Disabled
3. Bracketing order (page 62)
Options: 0: Metered value, under, over (initial setting)
1: Under, metered value, over
Bracketing is normally performed in the order of the initial setting (page 62).
However, this Bracketing order can be changed to be performed from
negative compensation to positive compensation.
4. On-Demand Grid Lines superimposition display (page 5)
Options: 0: Not displayed (initial setting)
1: Displayed
At initial setting, On-Demand Grid Lines (page 5) are not displayed in the
viewfinder. However, they can be set to be displayed.
Menu/Features of Custom Setting—continued
5. Illumination for superimposition (page 4)
Options: 0: Automatically illuminated for low light (initial setting)
1: Cancelled
2: Always illuminated
At initial setting, selected focus area (focus brackets) in the viewfinder are
temporarily illuminated in red depending on the subject brightness for easy
identification. However, they can be set not to be illuminated or always
illuminated no matter the subject brightness.
6. Focus area selection (page 42)
Options: 0: Normal selection (initial setting)
1: Enables successive rotation of focus area selection
At initial setting, the focus area can be selected by pressing the focus area
selector in the desired direction. However, it can be set to be changed
continuously in the same direction. For example, when the top of the focus
area selector is pressed, focus area continues to change from top, bottom,
middle and so on. With this option, focus area can be switched to the opposite
position without pressing the opposite position on the focus area selector.
7. Auto Exposure Lock when shutter release button is lightly pressed
(page 58)
Nikon
file:///D|/CAMERA REPAIR/Nikon F80/F80.htm (47 of 78) [3/19/2004 11:39:25 PM]
