99
98
• Use two CR2-type 3V lithium batteries
Use two CR2-type 3V lithium batteries.
• Change the batteries well before the end of their life and prepare spare batteries
before important photographic occasions.
• Turn the camera power off when changing batteries
Turn the camera power off before changing batteries and insert the batteries with
´
and
‰
ends positioned correctly.
• Stains on the battery poles may cause lack of contact. Wipe the batteries well
with a dry cloth before installing.
• Use fresh batteries at low temperatures
Battery power diminishes at extremely low temperatures and the camera may not
function properly with old batteries. Use a fresh set of batteries at low
temperatures, keep spare batteries warm, and use them alternately.
• Film advance speed lowers and number of usable film rolls becomes less at low
temperatures. However, battery power may recover when the temperature
returns to normal.
• Do not throw batteries into a fire or short circuit batteries
Do not throw batteries into a fire. Do not short, disassemble, heat or charge
batteries.
WARNING
Do not leave
Keep batteries out of children’s
reach.
If someone accidentally swallows batteries,
call a doctor immediately.
Notes on Batteries
Troubleshooting
LCD panel
Viewfinder
ƒEE
blinks
ƒEE
blinks
ƒEE
blinks
ƒEE
and
fi
blink
M
appears
—
M
blinks
—
o––
and
—
frame counter
blink
ƒ--
blinks
ƒ--
blinks
E
appears
—
Err
and
E
blink
Err
blinks
Cause
• CPU Nikkor lens other
than G-type is not set to
its minimum aperture.
• Attached Speedlight is
not set at TTL Auto
Flash in
a
, Vari-
Program or
P
mode.
• Batteries are nearing
exhaustion.
• Batteries are just about
exhausted.
• Batteries are
exhausted during film
rewind.
• Non-CPU lens is
attached or lens is not
attached.
• Film is not correctly
installed.
• Film is not correctly
advanced.
Page
18
92
17
17
66
19,
88,
89,
90
21
21
Remedy
• Set lens to minimum
aperture.
• Set the Speedlight
flash mode to TTL, or
set the camera’s
exposure mode to
S
,
A
or
M
.
• Have fresh ones ready.
• Turn the power off and
replace batteries with
new ones.
• Replace batteries with
new ones or recharge
batteries and turn the
power on again, then
press two
„
film
rewind buttons
simultaneously for
more than 1 sec. to
start film rewind again.
If this warning appears
frequently, contact
authorised Nikon dealer
or service centre.
• Attach CPU lens
(except IX-Nikkor).
With a non-CPU lens,
set the exposure mode
to M and set the
aperture with lens’
aperture ring.
• Reload film.
• Reload film.
MISCELLANEOUS
F65 (E) 02.12.27 5:43 PM Page 98
