Niko Touchscreen 2, Manual

Page: 52 / 70

Follow the steps below to mount the touchscreen 2:
1
Screw the mounting plate onto the wall using the four screws and connectors supplied.
• Mount the mounting plate in a central position on top of the flush-mounting box.
• Make sure the mounting plate is level.
• The unevenness of walls cannot exceed 2 mm.
2
Connect the green screw connector supplied to the 24V power supply cable while observing the polarity as indicated
on the back of the touchscreen 2.
• If you are using a PoE power supply, you do not need a separate 24V power supply cable.
• Only use the Niko PoE power supply type IEEE802.3af.
• The green screw connector supplied (24V power supply) is suitable for a maximum copper diameter of
1.5 mm².
3 Mount a RJ45 connector on the twisted pair cable (UTP, STP or FTP) according to T568B.
Min.
1,50 m
52
Touchscreen 2