Congratulations on your purchase of this product from the Niko Access Control range.
Please read the complete manual before attempting installation.
1. LEGAL WARNINGS
- Read the complete manual before attempting installation and activating the system.
- The installation has to be carried out by a qualified person and in compliance with the
statutory regulations.
- This user manual has to be handed over to the user. It has to be included in the electrical
installation file and has to be passed on to any new owners. Additional copies are available
on the Niko website or via the support service.
- During installation, the following has to be taken into account (not limited to list below):
- The statutory laws, standards and regulations;
- The state of the art technique at the moment of installation;
- This user manual, which must be read within the scope of each specific installation, only
states general regulations;
- The rules of proper workmanship
- In case of questions, you can consult Niko’s support service or contact a registered control
organisation.
Support Belgium:
Support Slovakia:
+32 3 760 14 82
+421 263 825 155
website : http://www.niko.be
e-mail: [email protected]
e-mail: [email protected]
In case of a defect, you can return your product to a registered Niko wholesaler, together with
a clear description of your complaint (Conditions of use, stated defect…).
2. DESCRIPTION
This flush type loudspeaker (10-880) and extension (10-881) of the Niko Access Control
range are designed as a door telephone system. These components can be flush mounted
behind a panel with bell push buttons. Up to 16 bell push buttons can be connected to the
flush type loudspeaker. An adjustable microphone and loudspeaker are provided. The ex-
tension can be connected to the flush type loudspeaker by means of the supplied cable. The
extension allows for up to 32 additional bell push buttons to be connected. Communication
always passes via the built-in door loudspeaker (10-880). These components must be used
in combination with one or more internal units and one or more power supply modules of
the Niko Access Control range. For basic systems, a 2-wire connection is sufficient.
3. INSTALLATION
Which cables are required?
Niko advises the following:
- JYSTY(-F2) 3 x 2 x 0,8mm
10-880 & 10-881
17
