4
When installing a Ni-Cd battery pack, make sure that the power switch of the vehicle is OFF.
When you connect the connectors. Make sure the vehicle
switch is in the “OFF” position.
Fixed connectors properly.(The connectors are designed to be
connected in only one way so that the positive and the
negative terminals are connected accurately.)
Disconnect the connectors immediately after played.
When you disconnect the connectors, be careful do not pull the
wire too strongly.
Avoid short circuits because it is very dangerous.
Remove all the batteries both from the vehicle and the
transmitter after played.
4
5
6
1
2
3
Slide the battery lid and remove.
Connect the battery's connector to the
motorbike's connector.
Install the Ni-Cd battery into the motorbike.
Return the battery lid to its original position.
Turn the battery lid stopper to its original
position.
CAUTION
Insert the connector (The and positions are as shown, do not connect wrongly.
Do not force in, it may cause short circuit; it is dangerous.)
Vehicle's
connector
Battery’s
Connectors
Vehicle's
connector
Battery’s
Connectors
Push and turn the battery stopper.
Motorbike's
connector
Battery's
connector
9.6V Ni-Cd
battery
Put the connector cable into
the connector holder.
