Firmly grasp the HR transmitter with both hands, one on
each end, making sure to touch the sensors on the back side
of the transmitter. There is no ON / OFF switch for the transmitter.
It sends a digital signal during the first 10 seconds of connection
with the sensors.
NOTE:
If you are unable to enter HRM LINK OK screen before
the 10 seconds expires, wait two minutes for the HR transmitter
to automatically turn off and try again.
After a few seconds the watch should display HRM LINK OK.
The watch has located the digital ID of the HR transmitter
and will store the ID until you either change the watch battery
or reset the watch.
14
Linking the HR Transmitter to the Watch
The HR transmitter has a unique digital ID to avoid crosstalk with other transmitters. Before your transmitter can
communicate properly, the watch must be linked to the HR transmitter to establish and share this ID. The original
transmitter which came with the watch was linked at the factory. Once linked, the digital ID of your HR transmitter
is stored by the watch until you change the watch battery or reset the watch. Follow steps through to re-link
the original or any replacement transmitters to the watch.
2
Scroll to RUN or
INTR mode
3
4
Press and hold all
four side buttons
simultaneously
until the watch
beeps and all
segments of
the watch LCD
flash in the display
SENSORS
