12
Operation (continued)
5
On-board controls
6
Recording audio message
NOTE:
Before removing Micro SD card from the slot, please
press and hold the mode button on the bottom of the
Nightwatcher NW720 for 3 seconds to stop the light
turning – the LED will flash orange. To resume
working, press the mode button once.
□
Reset button:
restore functions to default settings
- Press RESET button once each time you turn on
unit.
- In case of system malfunction, please press once.
OFF/REC:
Please press OFF/REC button to
remove Micro SD card. Please remove card within
30 seconds of pressing the OFF/REC button to
avoid loss of data.
TIME/DATE SET
OFF/REC
RESET
□
Audio mode:
for selecting which audio message
will play when motion sensor detects movement.
- Pre-set default is “silent mode”
- Push once for “doorbell chime”
- Push again for “dog barking”
- Push once more for the message you recorded
(Message 1)
- Push again for additional message you recorded
(Message 2- you can record up to 2 messages at a
time)
AUDIO MODE
SET/REC
PLAY/ERASE
MIC
□
Recording:
1. Press the SET/REC button for 3 seconds, and you
will hear a single beep. After the beep, start recording
your message by talking into the microphone (see fig.
9). Push the button again to stop recording, and you
will hear a series of 2 beeps, meaning the recording
is finished. If you do not push the button again after
you have recorded the message, the recording will
stop automatically after 10 seconds.
2. Nightwatcher NW720 can hold 2 self-recorded
messages. If you have recorded one message,
repeat above step for message 2.
3. If you hear a series of 3 beeps when you want to
record your message by pressing the SET/REC
button for 3 seconds, this means the self-recorded
messages are full, please erase previous messages.
□
Play/Erase:
allows you to listen to and erase
messages
1. If you have only recorded 1 message, push the
button one time to listen to recorded Message 1. If
you wish to erase it, press the PLAY/ERASE button
and hold it for 3 seconds. You will hear a series of 2
beeps, indicating the message has been erased.
2. If you have recorded 2 messages, push the button
one time to listen to the first message, and push it
again to listen to the second message. If you want to
erase a message, select that message, and after
listening to it, push the PLAY/ERASE button and hold
it for 3 seconds to erase it.
3. If message 1 is erased, message 2 will
automatically become message 1. The next message
you record will then become the new message 2.
