Your NIGHTSEARCHER PANTHER HID rechargeable lamp has been designed
to provide you with excellent performance for many years.
Important: Please read these instructions carefully to ensure the safe and
effective use of this product.
Specifications
Part Number
NSPANTHERHID
Light Output
5200/80 Lumens
Voltage
14.8V
Running time on High beam
2.0hrs
Running time on Low beam
18hrs
Charge time
8hrs
Battery
14.8V x 7.8 A/h Lithium-Ion
Main beam
50W HiD Xenon
Secondary beam
3W Luxeon LED
Product size (mm)
L260xW150xH180
Product weight (Kg)
3.10
Box size (mm)
L265xW220xH195
Boxed Weight (Kg)
3.70
Whilst every effort has been taken to ensure that the accuracy of the information
supplied in this booklet is correct at the time of going to print, the Nightsearcher
policy of continuous improvement determines the right to change specification
without notice.
Important Warning
For safety reasons, please bear in mind that this is a high powered professional
lamp, which generates considerable heat if left switched on or in a confined
space, this is due to the heat emitted by the high powered bulbs. Please ensure
that the lens is not obstructed by any flammable material, including the shoulder
strap. It is also recommended, when the torch is not in use, to unscrew the fuse
cap by half a turn or remove. This will prevent the lamp from turning on if the
switch is accidentally knocked, especially when in transit.
Store in a safe dry place and away from children.
The mains charger is CE Rated and should only be used indoors.
Charging Instructions
Always charge the lamp before use and ensure the switch is in the off position
whilst charging.
To recharge simply connect your Panther HiD Charger into the mains supply,
connect the jack plug into the Nightsearcher Panther the LED on the charger will
turn Red to show the unit is charging. When the battery is fully charged the
charger LED will turn Green. The Lithium-ion battery performs at its maximum
capacity after being charged five or six times.
Warning only use the charger
provided with your Panther HID any other charger will damage the battery.
Please ensure the 10Amp fuse is fitted securely in holder before use.
Maintenance Instructions
To change the bulb:
1.
Unscrew the lightfront of the Panther and pull away from the case.
2.
Diconnect the two in line connectors by lifting the clip.
3.
Unscrew the two retaining screws and extract the bulb. Care must be
taken not to touch the new bulb with bare hands, as this will impair the
performance and life of the bulb
4.
Refit new bulb into holder and refit the lamp in reverse order as taken
apart.
To change the battery:
1.
Remove the Fuse from the fuseholder by unscrewing it in an anti
clockwise direction before you start to undo the lamp.
2.
Open the lamp by un-screwing the lightfront (Lens) of the Panther in an
anti clockwise direction, once fully unscrewed, remove the metalic
reflector (containing the bulbs) from the panther case.
3.
Disconnect all the connections to the PCB to remove the battery pack.
4.
Refit in reverse order as taken apart.