Before using your NightSearcher product, please read this user manual, it contains important
safety information and operating instructions. Following this advice will help ensure that your
product operates to its maximum potential.
Light Output
1500 / 1000 lumens
Light Source
9 Cree® LEDs
Running Time
8h / 14h
Charge Time
6h
Battery
14.8V 7.8Ah Li-ion
Product Size (mm)
L260 x W224 x H 204
Product Weight (kg)
1.6
NS Part No
NS750LEDLITE
Supplied with
Detachable shoulder strap and mains charger
The Light Emitting Diodes (LED) can last 50, and seldom need to be replaced. If there
is any malfunction of LED, please contact Nightsearcher Limited or an authorised distributor.
BATTERY CHARGING
Turn the flashlight to the OFF; connect the charger to the charging socket of the
Searchlight.
The LED indicator (located on the charger) will turn RED.
When the battery is fully charged, the LED indicator will turn GREEN.
Disconnect the charger from the AC power supply and then disconnect the charger
from the Searchlight.
Recharge time is approximately 6h if completely discharged OR prorata if not.
Recharge for 12 hours before first use.
NOTE:
This Searchlight is powered by Lithium-Ion rechargeable battery, Unlike Lead acid
batteries, Li-ion require low charge maintance and can be left fully discharged without
damaging the battery.
NOTE:
The Jack plug connection the light to the power pack should be removed before
packaging/in transit/storage to prevent the lamp from accidentally switching ON.
Press the ON/OFF switch once: High intensity
Press the ON/OFF switch a second time: Low intensity
STROBE AND SOS
Press the ON/OFF switch a third time: Flashing
Press the ON/OFF switch a forth time: Strobe
WARNING:
The Strobe mode of this lamp is rapid and intense, which can trigger seizures in
photosensitive epilepsy.
Use a small brush or blow dry air to clean any dust inside the reflector.
Use lens cleaner and cotton swab, to remove any fingerprints on the lens.
Do not use the Searchlight for diving; it is not suitable for the high pressure underwater
environment.
If water gets inside the Searchlight, remove the battery immediately and place in a
well ventilated area.
CHANGING THE BATTERY
Unscrew two black screws located on the top of the power pack case
Remove the foam block holding the battery in place and lift the battery out of the
lamp
Pull off the crimp connectors careful not to touch them together and push onto the
new battery, ensuring a correct terminal connection (i.e. RED to positive, BLACK to
Negative)
Refit in reverse order of the above.
Please read the instructions below before charging the flashlight:
BATTERY
Before using the lamp for the first time, or if you have not used it for a long time, you
need to fully charge the flashlight for 12hrs.
Do not expose the battery to excessive heat, to do so may cause an explosion.
Do not use metal objects to short circuit the positive and negative end of the battery.
Do not dispose of the battery in the domestic waste, please use the correct method of
disposal.
Do not solder directly on to the battery.
Do not let the battery become wet or immerse the battery in water.
If there is evidence of leakage from the battery do not touch the battery with bare
hands. If your skin or your clothes come into contact with any leaked substance from
the battery, clean with water immediately.
Should any leaked substance from the battery come into contact with your eyes, do
not rub your eyes, rinse with clean water immediately and seek medical assistance as
soon as possible.
Keep the battery away from the children.
The operating temperature range of the flashlight’s battery is listed below :
- Charging temperature range: 0°C-45°C / Discharging temperature range: -20°C-60°C
GENERAL
The instructions hereunder list the safety measures for operating your flashlight and
charger:
Do not use any chargers other than those provided. Failure to do so could cause fire,
electrical shock or personal injury
Never use a damaged charger or charger with damaged lead. Should the charger or
its lead become damaged, replace the charger immediately.
Do not shine the LED directly into people’s eyes, as it may damage their eyesight.
Always make sure the flashlight system is disconnected from any power sources and
turned off when performing any routine cleaning or maintenance.
NOTE:
In case of any problems or questions please contact Nightsearcher LTD or an
authorised distributor.
SAFETY PRECAUTIONS
SEARCHLIGHT MAINTENANCE
ON / OFF AND MODE OPERATION
BATTERY INFORMATION
LED ASSEMBLY REPLACEMENT
SPECIFICATION