TM Series
Operating & Safety Instructions
USA – 05/11
Issue 01
13
3.3.3
MONTHLY SAFETY CHECKS
1)
Check the engine oil level (if applicable).
2)
Check the wheel nuts (torque 80ft lbs/110Nm or 110ft lbs/150Nm Traction Drive Option).
3)
Check outriggers for condition, security and operation.
4)
Check that the rotation gear worm is secure and correctly in mesh. Clean and re-grease.
5)
Inspect brakes for operation and wear.
6)
Grease the knuckle and centre post.
7)
Inspect the engine fuel tank for damage or leaks.
8)
Check telescopic boom wear pads and nylon studs (if applicable).
9)
Check that the end cap on the main knuckle pin is secure and the roll pin is in place.
10) Grease the tow hitch assembly.
11) Lightly oil the jack pad ball joints and outrigger housings.
12) Lightly oil the locating pins on outriggers and axles and the axle clamp bolts.
13) Oil and check the operation of manual jacks.
14) Check and adjust if necessary the Nylatron studs around the telescope boom.
3.3.4
ANNUAL SAFETY CHECKS
1)
Check that all pivot pins and their tag bolts are secure.
2)
Inspect for any cracks or badly rusted areas on booms and chassis.
3)
Change the hydraulic oil and the oil filters.
4)
Inspect the suspension on each axle unit.
5)
Check that rotation gear ring bolts are secure (torque 206ft lbs. 279Nm).
