TM Series
Operating & Safety Instructions
English/USA – 01/10
14
3.3.3
MONTHLY SAFETY CHECKS
1)
Check the engine oil level (if applicable).
2)
Check the wheel nuts (torque 110ft lbs/150Nm or 117ft lbs/160Nm Traction Drive Option).
3)
Check outriggers for condition, security and operation.
4)
Check that the slew worm is secure and correctly in mesh. Clean and re-grease.
5)
Inspect brakes for operation and wear.
6)
Grease the knuckle and centre post.
7)
Inspect the engine fuel tank for damage or leaks.
8)
Check telescopic boom wear pads and nylon studs (if applicable).
9)
Grease the tow hitch assembly.
10) Lightly oil the jack pad ball joints and outrigger housings.
11) Lightly oil the locating pins on outriggers (170M only).
12) Oil and check the operation of manual jacks.
13) Check and adjust if necessary the Nylatron studs around the telescope boom.
14) Every
three
months check and verify the calibration of the cage weigh system. See section
4.5.4 for the calibration procedure.
15) Every
Six
months perform a
thorough examination
in accordance with the ‘Lifting Operation
and Lifting Equipment Regulations’ (LOLER) 1998, Regulation (9)(3)(a).
3.3.4
ANNUAL SAFETY CHECKS
1)
Check that all pivot pins and their tag bolts are secure.
2)
Inspect for any cracks or badly rusted areas on booms and chassis.
3)
Change the hydraulic oil and the oil filters.
4)
Inspect the suspension on each axle unit.
5)
Check that slew ringbolts are secure (torque 155ft lbs. 210Nm).
6)
Inspect the wear of jack threads (manual jacks).
Summary of Contents for 170H Series
Page 2: ......
