1
2
3
4
G E T T I N G AC C E S S F O R FAC E P L A T E
O P E N I N G F L A P
R E M OV I N G FAC E P L A T E S C R E W S
R E M OV I N G FAC E P L A T E
• If faceplate modules have been specified for site wired connections, it
will be necessary to remove faceplate modules.
• Start by removing one Allan head machine screw from the bottom
corner of either end plate.
• Allan key is provided.
• Once the two machine screws are removed from the endplates, rotate
the aluminum flap at the base of the faceplates to expose Phillips head
faceplate screws.
Important!
• This electrical device is provided fully wired and should not be
tampered with.
• Tampering with this device voids warranty and may cause electrical shock.
• Please note, for detailed instructions about this Vox Forum - see the last
page after the installation photographs.
• For information please call Nienkamper Customer Service at 1-800-668-9318.
• For e-mail inquiries:
• Each faceplate module is fixed with two machine screws.
• Remove the screws below the faceplate to be removed.
• Once faceplate screws have been removed,
faceplate is easily taken out of the assembly.
• Complete connections to the faceplate module and re-install
opposite to removal.
!
