www.nkrowing.com.au
8
Tips to Help You Get the Most From Your Cox-Box
· Make sure that the CoxBox is carried by the handle, and NEVER by the microphone. After use, detach the microphone, and do not store the unit with the
mic attached.
· Keep your CoxBox clean by rinsing it off after use, ESPECIALLY if you row in salt water.
· Store your CoxBox in a cool, dry place. Avoid leaving it in severe heat or cold (such as the dashboard of a car or an unheated boathouse in the winter)
which can greatly shorten the life of the rechargeable battery pack.
CHARGING
· Recharging: Recharge a regularly-used CoxBox whenever possible to ensure that it will have enough power for the next practice. A fully drained CoxBox
battery pack requires 10 hours on charge to attain maximum capacity. At the end of the season, charge the unit for 10 hours, disconnect the microphone
and charger, and store in a cool dry place until ready to use next season.
· Memory Effect: It is not necessary to try to discharge the CoxBox batteries fully between charging - there is virtually no memory effect in modern lithium
batteries.
·BATTERY LIFE
The life of your battery depends upon many things: the age of the battery pack, the volume and talkativeness of the coxswain, and the extent of charge.
Here are some performance guidelines that should help you plan your CoxBox use.
· A fully charged battery will power a CoxBox with NO audio (volume turned all the way down) for 25 hours.
· With the volume turned all the way up, the battery can supply power for 60 minutes of continuous talk.
· Therefore, with an average volume setting and a coxswain talking less than half the time, a fully-charged CoxBox will provide at least four hours of power,
and usually more.
· Having the Coxswain turn the volume down as low as possible will help prolong the battery life.
· If your CoxBox unit is more than three years old, the battery performance will decrease. Simply replace the battery. If you're not sure how old your unit is,
give the Service Department at NK a call and they can research your unit's serial number to tell you when it was last serviced.
Visit www.nk.com.au for more maintenance and troubleshooting tips, or contact NK
email support on [email protected]
Cox-Box Maintenance
If you row, cox or coach a coxed boat, you know the CoxBox is an important part of every practice or race. Though designed to perform in conditions that
would destroy most electronics in minutes, there are a few things you can do to help your CoxBox last longer and perform better. For every waterproof
electronic product, the connections are the potential trouble spots. NK sells a complete Cox-Box Maintenance Kit with everything needed to make it easy to
maintain the connections on your equipment. Follow these steps to keep your Cox-Box, Cox-Vox, Microphones & Wiring static-free and reliable for years.
Cox-Box Panel Connectors - MONTHLY WASH the Cox-Box panel with warm water and mild soap. RINSE well. DRY thoroughly
ROTATE DRILL BIT
inside metal sockets of
rubber P5 connector
to dislodge dirt and
corrosion and lift debris
out of sockets.
APPLY
ELECTRICAL
CONTACT GREASE
from syringe inside
metal sockets. Avoid
over filling sockets or
getting into rubber.
USE FOAM SWAB to
apply SILICONE from
small plastic tub to...
OUTSIDE OF P5
until a visible film of
SILICONE covers
surface. (Keep foam
swab in provided bag
for future use.)
ROTATE DRILL BIT
inside metal sockets of
rubber P2 connectors
to dislodge dirt and
corrosion and lift debris
out of sockets.
APPLY ELECTRICAL
CONTACT GREASE
from syringe inside P2
metal sockets. Avoid
over filling sockets or
getting onto rubber.
USE FOAM SWAB
to apply SILICONE to
outside of P2 connectors.
Reconnect all P2/R2
connectors firmly.
Speaker/Harness Connectors - TWICE A YEAR (End of Season)
