WARNING:
Risk of cutting
(possible ejection of metal
sheet)
WARNING:
Risk of crushing
(punch moves towards mould)
BA
W
-ALS 50X35_50X55 01/20 GB
WARNING
(see figure 06)
Niedax GmbH & Co. KG -
Asbacher Straße 141 - D-53545 Linz/Rhein
Tel.: +49 (0 26 44) 56 06-0 - fax: +49 (0 26 44) 56 06-13 - [email protected] - www.niedax.de
•
Risk of crushing
exists between the punch and the mould of the notching tool.
•
Risk of cutting
exists at the cut. Depending on the material of the cut metal sheet, it is
possible, that the cut sheet section gets ejected in the direction of the drive / basic unit.
One hand grips the blank head (1.1) of the basic unit while the other grips the handle (1.6)
including the operating switch (1.4) of the basic unit (see figure 06).
The notching tool has to be held vertically to the side wall of the surface metal raceway in
order to insure a clean and vertical cut of the side wall and to eliminate the risk of jamming
the notching tool. The red hydraulic tank points to the floor. The punching process has to be
visually observed by the operator.
6
/8
figure 06
figure 04
figure 05