0472-0008-01
1 Introduction
The SK-Keypad Remote is an inexpensive numeric LED display. The SK-Keypad Remote emulates the keypad of the drive and has the same user
interface to show the status of the drive, and the value of the currently selected parameter.
N
The SK-Keypad Remote will assume 'RTU' master protocol. When connected to the RJ45 serial communications port of the drive the watchdog will
automatically be enabled. If the communications are lost or disconnected the drive/keypad will trip SCL.
N
The SK-Keypad Remote is rated to IP65 when panel mounted and the seal fitted as described overleaf.
2 Understanding the SK-Keypad Remote
2.1 Display
The display consists of a six-digit display, which will show different information depending on the display mode selected as shown below.
The five function mode LED’s will light depending on the selected mode of the Function key.
2.2 Control buttons
*Keypad control mode is selected by setting Pr
05
= PAd (4) on the drive.
Function key
The Function key can be selected by Pr
6.13
, the selected function is indicated by an associated function LED on the SK-Keypad Remote. Setting
Pr
6.13
to 0 will disable the Function key. Pr
6.11
will be continuously updated by the state of the Function key for all selected modes (Pr
6.11
= state of
the Function key).
Modes:
0. No function (Function key disabled)
1. Forward / Reverse toggle
Pressing the Function key will toggle between the forward and reverse direction of the motor.
SK-Keypad Remote Installation Sheet
The SK-Keypad Remote is intended for use only when mounted on a cubicle door with the drive, it is not suitable for hand-held use.
Operation in any other fashion may cause a hazard and invalidates the warranty.
Button
Description
Up and Down key
The Up and Down keys are used to select parameters and edit their values. In
keypad mode, they are used to increase and decrease the speed of the motor.
Mode key
Used to change the mode of operation of the drive.
Start key (green)
Starts the drive in keypad mode.*
Stop / Reset key (red)
The Stop key is used to stop and reset the drive in keypad mode. It can also be
used to reset the drive in terminal mode.
Function key
The Function key provides one of five functions selectable by Pr
6.13
Forward / Reverse toggle (1), Run reverse (2), jog (3), Auto (4), user defined
function (5).
WARNING
NOTE
NOTE
M
M
M
Status mode
Parameter
view mode
Parameter
edit mode
Status
Parameter
value
Parameter
number
(flashes)
Parameter
value
Parameter
number
Parameter
value
(flashes)
Function
Mode LED’s
(x5)
Function
Mode LED’s
(x5)
Function
Mode LED’s
(x5)
M
