2. Installation
CAUTION
Remove mains and control voltage from the soft starter before attaching or removing
accessories. Failure to do so may damage the equipment.
2.1 Installation Procedure
1. Remove control power and mains supply from the soft starter.
2. Fully pull out the top and bottom retaining clips on the module.
3. Line up the module with the comms port slot.
4. Push in the top and bottom retaining clips to secure the module to the starter.
5. Insert the network connector.
6. Apply control power to the soft starter.
Figure 2-1 Attach the module to the starter
1
2
3
10
17
8.
B
Figure 2-2 Remove the module from the starter
Remove the module using the following procedure:
1. Remove control power and mains supply from the soft
starter.
2. Disconnect all external wiring from the module.
3. Fully pull out the top and bottom retaining clips on the
module.
4. Pull the module away from the soft starter.
03
55
0.
B
Profinet Module: User Guide
5
Issue: B
www.nidec.com
