Rev. 0 - 11/12/2020
OPERATING MANUAL
OPERATING MANUAL
EN
EN
15/40
8.2 Motor - driver connections
In the standard arrangement of the FDP fan, the motor is turning clockwise when seen from the cable-entry side, and the electrical
connections of the motor cable to the driver board are made as shown in the following figure.
The actual position of the motor connections on the printed circuit board may differ, between different driver models.
These connections are carried out by
Nicotra Gebhardt
and cannot be modified by the end user.
WARNING
WARNING
9. INSTALLATION
The fan installation must be carried out only by competent and qualified staff.
9.1 Commissioning
Work on the device/system by unqualified personnel or failure to comply with warnings can result in severe personal injury or
serious damage to material.
Only suitably qualified personnel trained in the setup, installation, commissioning and operation of the product should carry
out work on the device/system.
The FDP fan must be grounded through the PE connector on the driver.
The following terminals can carry dangerous voltages even if the driver is inoperative:
• the power supply terminals L, N or R, S, T
• the motor terminals U, V, W
WARNING
WARNING
In the final installation, the device shall be directly connected to the supply terminals and shall have a contact separation in all
poles, providing full disconnection under overvoltage category III conditions.
WARNING
WARNING
Summary of Contents for EC FAN FDP
Page 2: ......