10
TABLE OF CONTENTS
1. Safety Instruction
2. Technical Specification
3. Installation
4. How to Control the Unit
4.1 Master/Slave operation
4.2 Easy controller CA-8
4.3 Universal DMX controller
6. DMX 512 Configuration
7. DMX 512 Connection
8. Troubleshooting
9. Fixture Cleaning
11
1. Safety Instruction
WARNING
Please keep this User Manual for future consultation. If you sell the unit to another
user, be sure that they also receive this instruction booklet.
Unpack and check carefully there is no transportation damage before using the unit.
Before operating, ensure that the voltage and frequency of power supply match the
power requirements of the unit.
It’s important to ground the yellow/green conductor to earth in order to avoid electric
shock.
The unit is for indoor use only and use only in a dry location.
The unit must be installed in a location with adequate ventilation, at least 50cm from
adjacent surfaces. Be sure that no ventilation slots are blocked.
Disconnect mains power before fuse replacement or servicing.
Replace fuse only with the same type.
Make sure there are not flammable materials close to the unit while operating as it is
fire hazard.
Use safety cable when fixes this unit.
Maximum ambient temperature is TA: 40
℃
and don’t operate it where the temperature
is higher than this.
Unit surface temperature may reach up to 60
℃
. Don’t touch the housing bare-hand
during its operation. Turn the power off and wait for 15 minutes for cool down before
replacing bulb or serving.
In the event of serious operating problem, stop using the unit immediately. Never try
to repair the unit by yourself. Repair carried out by unskilled people can lead to
damage or malfunction. Please contact the nearest authorized technical assistance
center and always use the same type spare parts.
Don’t connect the device to any dimmer pack or power pack.
Do not touch any wire during operation as high voltage might be causing electric
shock.
You should never look at the beam light directly in order not to risk any visual
disorders.
For power supply, do not connect in series much more than 51 units, use another
mains supply for next 51 units.
2. Technical Specification
Featuring 4 LED clusters & great programs, styled rocks the crowds with dynamic
scanning effects and powerful beams.
3 Operation Modes: DMX, Master/Slave, Sound Activation.
Optional CA-8 easy controller for enjoying instant lighting shows at your fingertips.
Low heat, low power consumption; No duty cycle, run all night.
Dip-switch for setting DMX address.
Perfect for discos, clubs, pubs, parties and mobile DJs.
Voltage: AC 230V~50Hz
Fuse: T 6.3A
Power Consumption: 12W
Please read the instruction carefully which including important
information about the installation, operation and maintenance.
