4/
Operation
DMX mode
Push UP ( ) or DOWN ( ), the LCD will appear: 5. Set Input.
Push ENTER ( ) you will see: 1.DMX Only.
Push ENTER ( ) again, LCD will show DMX Only Enable.
MASTER / SLAVE mode
Push UP (
) or DOWN ( ), the LCD will appear: 6. Unit Setup.
Push ENTER ( ) you will see: 1.Master
，
Push ENTER ( ) again LCD will show Master Only Enable you can set up Slave Enable in the same way.
DMX address
Push UP ( ) or DOWN ( ), the LCD will appear 1. Set Address.
Push ENTER ( ) again it will show 1. Start Address
Push UP ( ) or DOWN ( ), you will see 2.Patch address.
Push ENTER ( ) will show Patch addr :( ) Push UP ( ) or DOWN ( ), will show Patch addr :( ).
Running MAP program
1. Push UP (
) or DOWN ( ), the LCD will show 5.Set Input.
Push ENTER ( ) will show 1.DMX Only,
Push UP (
) or DOWN will show 2. MAP Only.
Push ENTER ( ) will show MAP Only Enable (it means the unit in mater).
EXIT ( ).
2. Push UP (
) or DOWN ( ), the LCD will show 3. Set Scenes.
Push ENTER ( ) will show 1. PlayShow. Push UP (
) or DOWN ( ) will show 2 Preset MAP.
Push ENTER ( ) again will show Preset MAP
Push UP (
) or DOWN ( ), will appear: Preset MAP: (1--10).
EXIT( ).
3. Push UP (
) or DOWN ( ), the LCD will show 3. Set Scenes.
Push ENTER ( ) will show 1. PlayShow.
Push UP (
) or DOWN ( ), will show 6. No DMX Scene.
Push ENTER ( ) again will appear Black Out, Push UP (
) or DOWN ( ) will show Run preset MAP
(running program in MAP.).
EXIT ( ).
4. Push UP (
) or DOWN ( ), the LCD will show 3. Set Scenes.
Push ENTER ( ) will show 1. PlayShow.
Push UP (
) or DOWN ( ), will show 7. Run Speed.
Push ENTER ( ) again will show Run Speed :( )
Push UP (
) or DOWN ( ) to select.
EXIT ( ).
5. Push UP (
) or DOWN ( ), the LCE will show 2. Set channels.
Push ENTER ( ) will show 1. Set preheat.
Push ENTER ( ) again, will appear 1.Preheat :( ).
Push UP (
) or DOWN ( ), will show Preheat:
（
0--127
）
.
EXIT ( ).
9
