7
8
Plug the wire into the socket. If the socket is controlled with a switch on the
wall, make sure it is on. The product handle has a power-on/off button,
pause button, two pressure control buttons and a switch between super
oxygen water and natural water on the front, of which the pressure control
button can be used to control the water pressure. After plugging-in, the
screen in the center of the body will show the operation status; press the
power-on button, and then the screen will show ten levels from 01 to 10.
The user may select a proper level to control the water pressure. The user
may select the super oxygen water (for disinfection) by pressing the switch
between super oxygen water and natural water. Set a 3-minute operation
from start to halt (note: The product needs to restart after the timer is over).
Take off the water tank, fill it with warm water, put on and tightly press the
water tank cover. The sound of cracking means the installation is
complete. The tank surface has volume marks in the unit of OZ. and ML.
How to Use
Prepare the Water Tank
Insert the nozzle into the middle of the knob at the top of the handle of the
water flosser. If the nozzle is locked in place, the colored ring shall be flush
with the end of the knob. To remove the brush from the handle, please
press the nozzle eject button and pull the nozzle out of the handle.
When using the product for the first time,
please adjust the pressure gear on the
handle of the product to the minimum
value (the gear displayed on the body can
be adjusted in gears 01-10). Start from
the lowest gear, turn on the switch on the
handle, and gradually increase the
pressure after the oral cavity adapts to it.
You can also increase the pressure under
the guidance of a professional dentist.
Insert and remove the nozzle
Adjust pressure settings
