Nice Nice Moon MOMB, Instructions And Warnings For Installation And Use

Page: 10 / 76

8 – English
EN
During the execution of the procedure, press the “ P ” key ( fig. 4 ) to select the
new command (during the procedure, every time the key is pressed the next
command is selected; see Table 5).
The procedure concludes when the “ L1 ” LED ( fig. 4 ), stops flashing or when
the card is passed to confirm the new command.
TABLE 5
N° of flashes Command
1 flash + pause Step-by-Step (command n° 1 factory-set)
2 f pause Opening
3 f pause Closing
4 f pause Partial open (command n° 2 factory-set)
5 f pause Stop
6 f pause Courtesy lamp
• Procedure for changing command n° 1, with card programmed in
STATIC 1 mode
01. Pass a valid card in front of the reader to activate command n° 1
02. The “ L1 ” LED ( fig. 4 ) emits a number of flashes equal to the type of com-
mand set, followed by a pause
03. Press the “ P ” key ( fig. 4 ) to select the new command (every time key P is
pressed, the L1 LED flashes an extra time)
04. Then pass the card again
05. At this point, the new command is memorised and activated
• Procedure for changing command n° 2, with card programmed in
STATIC 2 mode
01. Pass a valid card in front of the reader to activate command n° 2
02. The “ L1 ” LED ( fig. 4 ) emits a number of flashes equal to the type of com-
mand set, followed by a pause
03. Press the “ P ” LED ( fig. 4 ) to select the new command (every time key P is
pressed, the L1 LED flashes an extra time)
04. Then pass the card again
05. At this point, the new command is memorised and activated
• Procedure for changing command n° 1, with card programmed in
DYNAMIC mode
01. a) place a valid card near to the reader; this will emit an acoustic sound
b) hold the card still; the command will be activated after 1 second;
02. The “ L1 ” LED ( fig. 4 ) emits a number of flashes equal to the type of com-
mand set, followed by a pause
03. Press the “ P ” key ( fig. 4 ) to select the new command (every time key P is
pressed, the L1 LED flashes an extra time)
04. a) place the card near to the reader again; this will emit an acoustic sound
b) hold the card still until another acoustic tone (beep) is emitted)
05. At this point, the new command is memorised and activated
• Procedure for changing command n° 2, with card programmed in
DYNAMIC mode
01. a) place a valid card near to the reader; this will emit an acoustic sound
b) move the card away and place it near to the reader again within 2 sec-
onds to activate command;
02. The “ L1 ” LED ( fig. 4 ) emits a number of flashes equal to the type of com-
mand set, followed by a pause
03. Press the “ P ” key ( fig. 4 ) to select the new command (every time key P is
pressed, the L1 LED flashes an extra time)
04. a) place the card near to the reader again; this will emit an acoustic sound
b) move the card away and place it near to the reader again within 2 seconds
05. At this point, the new command is memorised and activated