8
VISUAL INDICATIONS & ACOUSTIC SIGNALS
CO Alarm-Control is equipped with a LED diode and a buzzer, signalling menu position and status of the device.
Table A1 - Device status indications
4 x BEEP
every 5s
4 x RED BLINK every
5s
Detected presence
of carbon monoxide
which can kill you!
1. Open the windows
2. Move to fresh air!
3. Contact emergency
services
1 x BEEP
1 x YELLOW BLINK
every 30s
Low battery level
Replace the battery
1 x BEEP
every 30s
–
Sensor error (does not
detect carbon mon-
oxide)
Reset the device,
replace if no effect
2 x BEEP
2 x CYAN BLINK every
30s
End of lifespan
Reset the device,
replace if no effect
3 x BEEP
every 30s
1 x BLUE BLINK every
30s
Heat alarm
Be cautious of fire
1 x BEEP
1 x WHITE BLINK
Tamper alarm
Check the housing
–
1 x GREEN BLINK after
button press
Device powered
–
1 x BEEP
1 x GREEN BLINK after
powering
Added to Z-Wave
–
1 x BEEP
1 x RED BLINK
after powering
Not added to Z-Wave
–
1 x BEEP
1 x MAGENTA BLINK
every 10min
Out of range
Check the Z-Wave range
–
CYAN BLINKING
Firmware update
Wait for completion
9
OPERATING THE DEVICE
Using batteries other than specified may result in explosion. Dispose of properly, observing environmental protection rules.
Use only type of battery specified in this manual and keep proper polarity!
CO Alarm-Control can be powered with CR123A (included) battery. Estimated battery life with device on default settings is 3 years (tested with
Panasonic Industrial Lithium).
9.1 - Checking battery level
CO Alarm-Control automatically warns about low battery with one yellow blink and a short beep, when battery level is low.
9.2 - Replacing the battery
In order to replace the battery:
1. Remove the device from the cover by turning it counter-clockwise.
2. Pull the paper strip to take out the battery.
3. Press and hold the button for at least one second.
4. Insert a new CR123A battery observing the polarities shown inside.
5. Attach the device to its cover by turning it clockwise and perform the battery test described above.
10
ASSOCIATIONS
Association (linking devices) -
direct control of other devices within the Z-Wave system network e.g. Dimmer, Relay Switch, Roller Shutter
or scene (may be controlled only through a Z-Wave controller).
Association allows direct transfer of control commands between devices, is performed without participation of the main controller and re-
quires associated device to be in direct range.
