Nibe S2125, Installer Manual, Page: 60 / 64

A
Accessories, 42
Adjustment, charge flow, 31
Alarm list, 40
Assembly, 8
B
Basic actions, 38
C
Charge pump, 23
Commissioning and adjusting, 30
Adjustment, charge flow, 31
Filling and venting the heating medium system, 30
Post adjustment and bleeding, 30
Preparations, 30
Start-up and inspection, 30
Communication, 27
Compatible indoor modules (VVM) and control modules
(SMO), 6
Component placement
Sensor placement, 21
Compressor heater, 30
Condensation, 10
Configuration using DIP switch, 29
Connecting accessories, 29
Connecting external control voltage, 27
Connections, 25
Connecting external control voltage, 27
Control, 32
Control conditions, 33
Control conditions, defrosting, 33
Control – Heat pump EB101, 34
Control - Introduction, 32
General, 32
LED status, 32
Control conditions, 33
Control conditions defrosting, 33
Control - Heat pump EB101, 34
Control – Heat pump EB101
Heat pump settings – Menu 7.3.2, 34, 36
Control - Introduction, 32
Master control, 32
Control module, 6
D
Delivery and handling, 7
Assembly, 8
Compressor heater, 30
Condensation, 10
Installation area, 9
Supplied components, 11
Transport, 7
Dimensions, 43
Disruption to comfort
Temperature sensor data, 37
Distribution box, 20
Disturbances in comfort, 38
Alarm list, 40
Troubleshooting, 38
Draining the heat pump, 37
E
Electrical circuit diagram, 52
Electrical connections, 24
Communication, 27
Configuration using DIP switch, 29
Connecting accessories, 29
Connections, 25
General, 24
Power connection, 25
Tariff control, 26
Energy labelling, 49
Data for energy efficiency of the package, 49
Information sheet, 49
Technical documentation, 50
F
Filling and venting the heating medium system, 30
G
General, 24
H
Heat pump settings – Menu 7.3.2, 34, 36
High room temperature, 38
I
Ice build-up in the fan, grille and/or fan cone, 38
Important information, 4
Compatible indoor modules (VVM) and control modules
(SMO), 6
Control module, 6
Indoor module, 6
Inspection of the installation, 5
Safety information, 4
Indoor module, 6
Inspection of the installation, 5
Installation area, 9
Installing the installation
Symbol key, 22
L
Large amount of water below S2125, 39
LED status, 32
Low hot water temperature or no hot water, 38
Low room temperature, 38
M
Marking, 4
Master control, 32
P
Pipe connections, 22
Charge pump, 23
General, 22
Pipe coupling, heating medium, 23
Symbol key, 22
Water volumes, 22
Pipe coupling, heating medium, 23
Post adjustment and bleeding, 30
Power connection, 25
Preparations, 30
S
S2125 does not start, 38
S2125 not communicating, 38
Safety information, 4
Marking, 4
Serial number, 4
Symbols, 4
Sensor placement, 21
NIBE S2125 Item register 60
Item register