Nibe EMK 300, Installer Manual, Page: 6 / 20

General
This accessory is used to measure the amount of energy
produced by and supplied by the heating installation
for hot water and heating in the building.
The function of the energy meter is to measure flow
and temperature difference in the charge circuit. The
value is shown on VVM 320's display.
Contents
Flow meter 1 x
Cable to flow meter 1 x
Connection kit (Lock spring and O-ring) 2 x
O-ring 6 x
Locking clips 1 x
Brass pipe connection nipple 2 x
Copper pipe (ø22) 2 x
Outline diagram
Explanation
Expansion vessel closed, heating medium CM1
Flow sensor, EMK 300 BF1
Indoor module VVM 320 EB15
Heat pump EB101
Safety valve, heating medium FL2
Connection, heating medium, flow XL1
Connection, heating medium, return XL2
Connection, docking in heating medium from
heat pump XL8
Connection, docking, out heating medium to
heat pump XL9
Designations according to standard IEC 61346-2.
Outline diagram EMK 300 with VVM 320
Note! This is an outline diagram. Actual installations
must be planned according to applicable standards.
-EB15
-EB101
-FL10
-XL8
-XL9
-QM41
-QM40
-XL1
-XL2
-BF1
Pipe connections
Install as follows:
The flow meter is installed on the supply line from the
heat pump, between XL1 and XL8 with the arrow
pointing down in the direction of flow.
The temperature is measured using the installation's
existing sensor.
6
English, Installer manual - EMK 300
GB