©
National Instruments Corporation
5
NI VXIpc-882 Installation Guide
Note
To optimize both memory capacity and system performance, use the same size and
speed memory module in each of the two module slots. The use of different size modules
in each slot is supported, but system performance will be slower than using two matched
modules. However, two mismatched modules will result in better performance than using
a single module.
Figure 2.
Installing a SO-DIMM in an NI VXIpc-882 Controller
Installing and Removing the Internal Hard Drive
Follow these steps to remove the internal hard drive from your
NI VXIpc-882 controller:
1.
Remove the controller from the chassis. See the removal instructions
in the
How to Remove the Controller from the VXI Chassis
section.
2.
Remove the component side cover. See the removal instructions in the
Removing the NI VXIpc-882 Component Side Cover
section.
3.
Remove the four screws under the solder side cover that hold the
hard drive in place. You will need a 2 mm hex driver to remove the
M3 button head screws.
1
SO-DIMM Socket XA1
2
SO-DIMM Module
3
SO-DIMM Socket XA2
3
2
1
