Removing Components
Removing Spring Terminal Blocks
Complete the following steps to remove a spring-terminal block from the REM-11190.
1
3
2
1
1.
Press the locking latch to release the spring-terminal block.
2.
Tilt the block toward the center of the module.
3.
Remove the connector from the module.
Removing the REM-11190
Remove all connections before removing the REM-11190, either by disconnecting the cables
or removing the spring-terminal block.
What to Use
•
Flathead Screwdriver
What to Do
Complete the following steps to remove the REM-11190 from the DIN rail.
1
1
2
1.
Insert the screwdriver and loosen the base latches on either end of the module.
2.
Remove REM-11190 perpendicular to the DIN rail.
REM-11190 Getting Started Guide
|
© National Instruments
|
9
