Connecting the cRIO-9067 to Power
The cRIO-9067 requires a 9 V to 30 V external power supply. The cRIO-9067 filters and
regulates the supplied power and provides power for the C Series modules. The cRIO-9067
has one layer of reverse-voltage protection.
The following table lists the POWER LED indicators.
Table 2.
POWER LED Indicators
LED Color LED Pattern
Indication
Green
Solid
The cRIO-9067 is powered on and the connected power supply is
adequate.
—
Off
The cRIO-9067 is powered off.
What to Use
•
Screwdriver, 2.54 mm (0.10 in.) flathead
•
Power supply, 9 V to 30 V, 25 W maximum
NI recommends the power supply listed in the following table for the cRIO-9067.
Table 3.
NI Power Supplies
Power Supply
Part Number
NI PS-15 Industrial Power Supply
(24 VDC, 5 A, 100 VAC to 120 VAC/200 VAC to 240 VAC input)
781093-01
What to Do
Complete the following steps to connect a power supply to the cRIO-9067.
1.
Ensure that your power supply is powered off.
2.
Remove the power connector from the cRIO-9067.
Caution
Do not tighten or loosen the terminal screws on the power connector
while the cRIO-9067 is powered on.
3.
Connect the power supply to the power connector, as shown in the following figure.
NI cRIO-9067 Getting Started Guide
|
© National Instruments
|
7