Specifications / Features
Power Output
2 x 200W RMS @ 8ohms THD+N <0.05% - all
channels driven simultaneously
Peak Power 300W into 8ohms any individual
channel
Frequency re/-0.5dB 20-20kHz
Dynamic range 100dB A-weighted @ full power
IM distortion (CCIF) 0.001%
TIM distortion 0.01%
Soft Clipping
NHTBus Features
Intelligent operation with NHT Controller
Monitoring of amplifier status
Amplifier control – on/standby
Utilizes Ethernet infrastructure
Protection features
Phase-to-phase short
Phase-to-ground short
Under voltage
Thermal protection
Rear panel connectors & components
2 Single-ended RCA input connectors
2 Pair of binding posts for speaker output –
banana spacing
12V Trigger input/output on 1/8” sub mini jacks
2
NHTBus connectors on RJ45
IEC mains voltage socket
Front panel features
2 Dual-color LED’s for each channel indicating
OK/Fault
Standby Touch Sensor
Standby indicator
Placement
The Power
2
amplifier may be placed on a shelf, or in a
standard 19" equipment rack using the optional rack ears
and hardware. Proper ventilation is required so the
Power2 will not overheat. Two inches of open space
above and below the Power2 is sufficent for proper ven-
tilation.
Note:
Due to the placement of the Power
2
power switch
on the rear panel, do not install the Power
2
in a wooden
box or similar enclosure where access to the power
switch is blocked or inconvenient. This also required for
proper ventiliation.
Ideally, the Power
2
should be placed in close proximity to
the NHT Controller or surround processor. Minimizing
cable lengths reduces the chance of noise pickup.
6
