Wall Speaker Applications
Unpacking your Speakers and
Assembly
There are a variety of placements and
applications possible. You can find the full
owners manual on line on the Absolute Wall
Speaker page or in the Service Center.
As you unpack your Absolute Wall speaker, you
will notice we have included some rubber pads
with adhesive backing (Fig. 1). You will need to
decide how you want to orient the speaker on the
wall, tweeter up or tweeter down. That will
determine where the keyhole bracket is to be
located. Then peal off the backing and stick
these near the two corners on the rear of the
speaker on the opposite side of the Keyhole
bracket as shown.
Mounting your speakers to the wall
The metal keyhole bracket (Fig 1.) on the back of
the speaker is designed to hang the speaker off a
single screw that sticks .20 inches (3/16") out of
the wall. The key hole mount can be moved to the
opposite end of the speaker if you need to invert
the speaker to get the tweeter closer the ear level
– this is particularly beneficial when mounting the
speaker higher on the wall.
WARNING! The speaker is HEAVY, be sure to
find a stud (the wooden kind) to fasten the screw
into. In absence of a stud – use suitable
hardware rated to support the Absolute Wall
Speaker's weight. Consider hiring a professional
to mount these speakers (and hide the wires).
Fig. 1
_
_
+
+
serial #
01
-XX
00000001
Model
Designed and
Engineered
in the USA
Made in China
Absolute
Wall
Speaker
Power RMS
Now Hear This
Benicia, CA
Nominal
Impedance
100W
6 ohms
(2) Rubber
Bump-Ons
