NHRC-10 User Guide
Page 34
Copyright
1999, 2000, 2001 NHRC LLC. All Rights Reserved.
3.10.2 Program or play courtesy tones
The NHRC-10 supports eight different courtesy tones. Courtesy tones are composed of
up to four segments of tones. Each segment has a tone frequency and duration.
The courtesy tones are played and programmed with command *71 as follows:
*71<n><ddtt ddtt ddtt ddtt>
where:
<n>
is the courtesy tone number to play or program. The
valid range of values is 0 to 7.
<ddtt ddtt ddtt ddtt>
is up to four sets of duration and tone.
Duration is in 10 ms increments, valid range is 01-99. Both digits must be specified.
Tone is the number of the tone from Section 6.1.3, the courtesy tone components table.
Example:
The default courtesy tone #0,(four 50MS bursts of notes E5, G5, B5, D6)
would be programmed like: *7100517052005240527.
Courtesy Tone Uses
Tone Use
0
Main receiver courtesy tone.
1
Main receiver courtesy tone, link alert mode, link receiver active
2
Main courtesy tone, link transmit enabled
3
Link receiver courtesy tone, link transmit disabled.
4
Link receiver courtesy tone, link transmit enabled.
5
Reserved
6
Reserved
7
Controller unlocked courtesy tone
Note:
Message 104 can be substituted for any courtesy tone by programming the first
segment as all zero. To program the normal courtesy tone to play message 104, use this
command: *7100000.
