S05-TH User’s Manual
3
2 Installing Mounting for S05-TH
Requirements:
Mounting fixtures
Drill with 5mm (0.2 inches) drill bit size (if using wall plugs) or 3.5mm (0.14 inches) drill bit size
(if not using wall plugs)
Size 1 Phillips screwdriver
a) Locate S05-TH with at least 15cm (approx.. 6 inches) spacing on each side (except on mounting
side) avoiding the following sources of interference: direct sunlight, air flow from vents, fans,
doors, windows, heaters, sources of steam, oil vapor, etc.
b) If necessary, pre-drill mounting holes using mounting cradle for alignment, then use appropriate
drill bit to drill the holes – 5mm (approx. 0.2 inches) if using wall plugs or 3.5mm (approx. 0.14
inches) if not using wall plugs.
c) If necessary, insert wall plugs into the 4 holes and use size 1 Phillips screwdriver to fasten the
screws securing the mounting cradle. Note: pay careful attention to the orientation of the
mounting cradle.
d) Install and remove S05-TH by placing it into and lifting it out of the cradle
Install -
Remove -
Initial hardware installation for S05-TH has been successfully completed.