Interface
Name
Interface Function
Interface Name
Interface Function
VIDEO
IN
Video input
AUDIO IN
Audio input
CVBS
CVBS
video output
USB 2.0
USB
storage device and mouse
AUDIO OUT
Audio output
DC 12V
Input12V
（≥
3A
）
direct current
VGA
VGA
video output
RJ45
Link the auto-adapt Ethernet
cable
1. Product Appearance Introduction
2. Hard Disk Installation
Top Cover
Rear Panel
Item
Name
Function
1
Power Indicator
Steady light when the power connection works.
2
HDD Indicator
Steady light when the HDD works.
3
Network Indicator
Steady or flashing light when the network connec-
tion works.
Take the following model as an example:
Compatible with 2.5-inch and 3.5-inch hard disks.
1
2
3
HDD
②
Align the screw holes on the hard
disk with screw holes on the base plate.
①
Loosen the screws on the base
plate.
③
Turn the device and use screws
to tighten the hard disk to the
bottom.
⑤
Align the top cover with the
base plate and gently close.
⑥
Use screws to tighten the top
cover to the base plate.
HDD
④
Plug in the hard drive cable
and power cable.
3.Local System Login
4.Web
Login
5. Common Problems and Troubleshooting
1. When turned on the XVR, it cannot normally boot up.
.
Incorrect power input.
.
Switch Mode Power Supply (SMPS) is broken.
.
The program upgrade in error.
2. XVR will restart automatically a few minutes after startup or fre
quently crashes.
.
Input voltage is unstable or too low.
.
The hard disk has bad sector or the hard drive cable is broken .
.
Switch Mode Power Supply is under capacity.
.
Bad heat dissipation, dusty or poor working condition.
.
XVR hardware failure.
3. Single-channel, multi-channel or all videos have no output.
.
Please check whether the power cable connected to the camera is
loosen.
.
Please check if the video input or output cables through the XVR
rear panel are ok.
.
Directly insert the video source into the display device and see if either
of them is defective.
.
Check the screen brightness, if the luminance values are all zero,
please restore default settings.
.
The video input signal is too week or no input signal.
4. Web
cannot log on.
.
Confirm whether the network is connected and check whether the
panel LINK or 100M LED displays properly. Use ping xxx.xxx.xxx.xxx
( the XVR IP) to check if the network is connected.
.
If the ActiveX control is blocked, please manually install the ActiveX
control.
After the normal startup, click the right mouse button and there will
be a login dialogue. Then enters the user name and password in the
input box.
In the factory default state, the user is
admin
, and the password is
12345
.
Admin is the default high-privileged user.
If the plug-ins cannot be loaded, you need to set IE as follows: Tools
—>
Internet
Options
—>
Custom Level
—>
ActiveX controls and plug-ins,
to enable all, and click OK.
Enter the IP address of the recorder in the browser address bar, and
connect. After a successful connection, it will pop up an input box as
shown below.
Enter the user name and password The factory default administrator
user name is
admin
, password is
12345
.
Take the following model as an example:
The appearance of products, including buttons, interfaces
and layout, are for reference only, and the actual delivered
goods shall prevail
.
