4
PREPARATION
UNPACKING THE
TURNTABLE
When you remove the turntable assem-
bly with its attached dust cover from the
box, be sure to also remove the supplied
rubber mat and 45 RPM adapter before
you store the packing material.
ASSEMBLING THE
TURNTABLE
Note:
The LIN (lead in), RET (auto re-
turn), and SW (tone arm switch) screws
on the bottom of the turntable are set at
the factory and should not be adjusted.
1. Open the dust cover.
2. Rotate the turntable’s platter until
one of the platter’s two larger holes
is above the drive motor spindle on
the turntable’s upper left side.
3. Remove the adhesive tape and two
ribbons from the rubber drive belt.
Be sure that the drive belt is not
twisted, then stretch the belt over
the drive motor’s spindle.
4. Remove the shipping wire which
holds the tone arm to the tone arm
rest.
Note:
Save this wire with the pack-
ing materials for future use.
5. Turn the turntable’s platter by hand
clockwise six or seven times to clear
the tone arm mechanism.
Drive Motor'Splindle
Summary of Contents for LAB-1100
Page 15: ...15 NOTES...
