7
6
Step
Image
Recommended
procedure
Parts and
installation
items needed
• Identify profiles or perforated rails for
equipment mounting.
• Position the perforated mounting rails
so as to have from high to low the
number of rack units stamped on each
column.
• In addition, the row of numbers on
each vertical rail must be facing each
other on both, the front and rear
sections of the unit.
• Proceed to insert the M6XL12
phillips-head screws from the inside
through the vertical mounting rails.
Then thread a flange nut so as to fix
them to the side bars.
4 perforated mounting
rails (C1)
8 M6xL12 phillips-head
screws (A)
8 M6 flange nuts
(A)
• Identify the two side panels. Both are
identical for this model.
• Next, identify one cam lock and key
set, including one lock offset plate.
• Install the cam lock in the opening
located on the side panels.
• Then insert the locknut and tightly
fasten o secure it in place.
• Proceed to attach the offset plate to
the lock from the inside, and tightly
fasten the assembly using the supplied
screw, flat and spring washers.
2 side panels
2 cam lock and key sets
2 lock offset plates
5
4
6
Step
Image
Parts and
installation
items needed
• Place bottom section of each side
panel over the outer edge of the cabinet
base.
• Slide the plastic retaining latches on
both sides of the panel to their lock
position.
• Turn the key to engage the cam lock.
• Identify the front tempered glass door.
• Next, identify one cam lock and key set,
including the 90° offset plate.
• Install the cam lock in the opening
located on the front door.
• Then insert the locknut and tightly
fasten o secure it in place.
• Proceed to attach the 90° offset plate
to the lock from the inside, and tightly
fasten the assembly using the supplied
screw, flat and spring washers.
1 front door
1 cam lock and key set
1 90° offset plate
• Identify the door pivot pin, the flat
metal washer and the two plastic
guides.
• Insert the pin plastic guides in the top
and bottom holes located on the front
section of the structure.
• Then fit the pin into the plastic guide
found on the right side of the bottom
panel and insert a metal washer.
1 door pivot pin
1 flat metal washer
2 pin plastic guides
8
7
9
• Identify the green/yellow pigtail
grounding cable.
• Locate the grounding copper studs on
the lower section of the door and on the
right corner of the bottom panel.
• Unfasten the nut from each stud and
remove one of the two copper washers.
• Connect one end of the pigtail
grounding cable to the enclosure stud,
and the other end, to the stud located
on the front tempered glass door.
• Replace the copper washer you just
removed and screw the nut back to
attach both ends of the pigtail.
• The enclosure assembly is now
complete.
Note:
This enclosure includes ventilation
unit(s) designed to improve air flow.
These operate with voltages of 110VAC
and 220VAC.
1 green/yellow pigtail
11
• Identify the front tempered glass door
and carefully lower it to engage the pivot
pin below.
• Pull down the spring lock located on
the upper right section of the door and
release it into the hinge hole of the
enclosure.
10
Recommended
procedure
