WIND DATA
4-30
6.5
C70 Configure NX2
To return to normal PAGE, press
SET
when the text [rET] is
displayed.
In the configuration you will be able to tell the Nexus Network where
you have installed the log and Wind transducer.
This is important because you may optionally install those
transducers at the Server too.
6.5.1 C71
Wind-master
[On]
= the Wind transducer is connected at the Wind Data
instrument.
[OFF] =
the Wind transducer is connected at the NX2 Server.
6.5.2 C72
Log-master
[On]
= the log transducer is connected at the Wind Data
instrument.
[OFF] =
the log transducer is connected at the NX2 Server.
6.5.3
C73 Function on terminal In3
Select function on the terminal pin 3. The following functions are
available:
[TMP]
Standard temperature function from the log transducer.
[TRM]
Use the external trim button for the STEER Pilot function.
[SPT]
Use the external trim button for the SPEED TRIM function.
[MOB]
Use the external trim button for the M.O.B. function.
[Roll]
Use the roll sensor to compensate Wind speed and angle.
(Not yet available, at the time for this manual).
When the selection roll is made, further settings in calibration can
be made to correct the offset angle. See C68 6.4.8. You may still
use the water temperature by connecting the log transducer at the
Server.
When Speed Trim [SPT] is selected, a press on the external trim
button will transmit the trim command on the Network to all
instrument. To be able to set both the STEER reference and the
TRIM reference, the optimum way is to connect one trim button for
speed to the Wind instrument and connect one trim button for
Compass and Wind angle to the Server. Such a installation gives
you the opportunity to trim speed and angle at two separate
buttons.
