OT1550-DM Intelligent Direct Modulated Optical Transmitter
- 12 -
4. Installing the OT1550-DM Optical Transmitter
4.1 Receiving and Inspecting
As you unpack your unit, inspect the shipping container and equipment for damage.
Save the shipping material for future use. If the container or the equipment is
damaged, notify both the freight carrier and us.
CAUTION
:
To protect yourself from potential injury and to protect
the equipment from further damage, do not perform any
operational tests if the equipment appears to be damaged.
4.2 Precautions
Heed the following precautions when working with the
OT1550-DM
.
Warning
Read the installation instructions before connecting the
system to the power source.
Warning
The plug-socket combination must be accessible at all
times, because it serves as the main disconnecting device.
4.3 Mounting OT1550-DM
4.3.1
Mounting
the OT1550-DM in the
Rack
Mounting the OT1550-DM in the standard 19 inch equipment rack:
1. Place the equipment in the rack.
2. Use four screws fixed the mounting lug on the OT1550-DM front panel to the rack.
3. Reliably ground the equipment. The ground terminal is on the rear panel.
4. Visually inspect each key (button) on the front panel to ensure that it is not trapped
under the edge of its hole. If a key is trapped, tap the key to enable it to move freely.
4.3.2 Connecting the RF Cables
Verify the RF input F connector type according to the ordering information, then
screw on the matched RF cable.
