09
INSTALLATION OF HARD DRIVE (OR SSD) IN BRIDGE PELLET
INSERT & REMOVE OF BRIDGE PELLET & MEMORY CARD MODULE
10
NSB-25 includes 2 slots for 2 bridge pellets (sold separately) which can hold
2.5 inches SATA Hard drive (or SSD). There is no limitation of capacity of hard drive
(or SSD), but the limit of the height is 9.5mm.
6. Installation of Hard Drive (or SSD) in Bridge Pellet
Cover the protection rubber (Filler) on hard
drive.
Take off the upper case of bridge pellet.
(The case is not screwed when you purchase.)
Connect hard drive to hard drive connector in
bridge pellet. To put it easily, recline the hard
drive and push it inside as deeply as possible.
Close the aluminum case and tighten 2 screws
on the connector side.
The bridge pellet and memory card module are interchangeable, it is easy to carry
and replace the bridge pellet. It can be connected to computer or equipped with
NSB-25, NSB-25 performs backup from the memory card to the bridge pellet.
7. Insert & Remove of Bridge Pellet & Memory card Module
Caution
●
Interchange the memory card module and bridge pellet when the
power is off.
①
②
①
②
①
Untighten the screw on the side.
②
Pull off the bridge pellet (or memory card module).
②
②
①
①
①
Push in bridge pellet or memory card module to each of those slots.
②
Tighten the screw on the side.
1. Equip the bridge pellet (or memory card module)
2. Remove the bridge pellet (or memory card module)