Nextech QV3868, Instruction Manual

Page: 7 / 12

6
IMPORTANT PRODUCT FUNCTION:
1. Video recording
When the SD card is inserted in and power is on, the dash camera will record
automatically. The red recording indicator will flash on the screen. From
00:00:00, press [Recording] icon to stop recording.
2. Take Photo
In video mode, slide your finger from left to right in the blank area of the
screen to take photos.
3. Playback
Press the [playback] icon to enter into photo album, then select the video or
photo you need to play back or view.
4. G-sensor
G-sensor is built into the camera. In case of a vehicle collision, the recorder
will lock the broken video of the accident and save it as a special image.
Meanwhile, a yellow scroll bar appears at the bottom of the display screen.
The locked image is not covered by the loop. Note: G-sensor supports
sensitivity adjustment, which can be changed in the Settings menu.
5. Loop recording
This dash camera can cycle over the recording without missing a second. The
cycle mode can be set in the recording menu. For example, the setting range is:
off /1 minute /3 minutes /5 minutes.
6. Date & time setting
In standby state, press [Settings] to enter the system Settings menu, and select
the date/time option by scrolling up/down. [Note] In order to effectively
record the date and time of obtaining evidence of driving safety accidents,
please set the correct time before using the product.
7. Connect to PC
Connect the device to the USB interface of the PC through a mini USB cable.
The screen shows three optional modes: USB storage, PC camera and charge.
8. Charge
When the power is connected, the charging indicator icon will be displayed
on the upper right of the screen and the charging icon will flash continuously
during the battery charging when device is working.
9. Screen saver
The LCD display can be automatically power off to make the product work at
very low power consumption; In the “screen saver” of the system menu, three
modes of “Off”, “1 minute” and “3 minutes” are optional. For example, select “3
minutes” to enter the power-saving mode after three minutes of power on and
turn off the display. The default is off.
10. GPS
This device has built-in GPS module. When the GPS icon turns green, it means
the device has successfully located.