12V/5A
5V/2.4A
12V/5A
5V/2.4A
Installing Cinema Pro in Vehicle
This device is specifically designed to be mounted behind the driver and/or
passenger seat(s).
1
Remove the headrest(s) and carefully route the
cable(s).
For Uno Cinema Pro
Route the T-cable into the hole of the pole on
the seat.
For Duo Cinema Pro
Route the T-cable 2 and T-cable 3 into the holes
of the poles on each side of the seat. Then from
the bottom of the seat, connect both ends of
the T-cable 2 and T-cable 3 to the T-cable 1
connectors.
2
Replace the headrest(s) into place.
3
Remove the screws to release both locking
latches on the stanchion mount.
4
Position the bracket on the bars of the headrest.
Fasten the screws on both locking latches to fix
the bracket firmly on the bars.
Note
z
To remove the player from the stanchion mount, pull and hold the
release latch upwards and then slide the player o
ff
to disengage
the connection.
Basic Connection
For proper connection method,
refer to the illustration.
5
Connect the player with the AV/Power cable
(one end of the car power cable) as shown in
the following illustration.
6
Slide the mount slot of the player into the
backplate of the stanchion mount fully until it
clicks into place.
Cigarette Charger
7
Adjust the player to the desired viewing angle.
