Nextar NS-BT007, Manual

Page: 5 / 8

Operation
Using By Connecting with Bluetooth AV Dongle
1. Press & Hold the Speaker Pairing Button for 8 Seconds until LED alternately
Flashes Red & Blue
2. Press & Hold the Dongle (Base) Pairing button for 8 seconds until LED
alternately Flashes Red & Blue
3. After steps 1 & 2 are completed - wait 3 - 5 seconds - LEDs on Speaker & Base
will Flash Blue to Confirm Pairing
4. Plug the 3.5mm Phone Jack on the Base into the Headphone Jack on your Audio
Device, then Press PLAY
Remark:
Initial Set Up should only required for first time use. If you change devices - then you will
need to repeat steps 1 – 3
Dongle & Speaker will exist the pairing mode after 1 minute if the pairing fails. To return the pairing
mode, turn off the device and restart step 1 - 2).Passcode of this speaker is fixed to “0000”.It can not
be paired with a bluetooth source device whose passcode is not “0000”.
7
Operation
Using By Connecting with Bluetooth Mobile phone
1. Press & Hold the Speaker Pairing Button for 8 seconds until the LED flashes red & blue.
Red & Blue
LED flash
2. Turn on bluetooth mode of Mobile phone and enter "Search Bluetooth device" mode.
3. Mobile phone will find a device name "NS-BT007." Select this device. Input passcode "0000."
Bluetooth Device
:
NS
-
BT007 Passcode
:
NS
-
BT 0 0 7
00 00
Selection Cancel OK Cancel
Remark: For other bluetooth source devices, passcode may be called”8888,” ”pass,” etc.
4. Mobile phone will ask "Authorize Auto Connect." Select YES.
Authorize Connect
:
YES NO
5. After pairing is successful, the Speaker LED will flash blue.
8