2. Use a spirit level to check that the fixing are level.
STEP ONE
• Lighting: 5 W LED (Total)
PARTS
1. Use the template (A) provided to mark on the wall
the position of fixings.
NOTE:
Place the template over the back of the product to
ensure the holes match the position of the hanging
brackets holes before drilling into your wall.
3. Drill three holes and insert an appropriate wall
plug into each. Insert the screws and tighten,
Leaving the screw head exposed by about 1/4 inch
(6mm).
1. Lift the engine into position ensuring that the
fixing clips attached to the unit are firmly hooked
over the screw heads.
FITTINGS
WARNING:
Always ensure intended wall area to be drilled is free
from hidden electrical wires, water and gas pipes.
NOTE:
Wall fixings are not included, please ensure wall
fixings are suitable for your wall type. If in doubt
Consult a qualified tradesperson.
2. Check that the hole in the bottom bracket aligns
with the position marked from the template
previously, then secure the bottom bracket on the
wall.
STEP TWO
1. Hook the securing bottom bracket (B) to the
chassis as shown in the diagram.
STEP THREE
Page 3 of 6
